Project - Snow Plant Pyramage Card

This Snow Plant is very striking.

For this one print:-

The Snow Plant (small) pyramage sheet onto quality white card
Both the red and the cream reverse floral trail papers from the Floral Red Digital Paper Pad onto quality white paper

To make the card, cover the front of an ivory or cream 7" x 5" card blank with the cream floral trail paper using double-sided tape.

Add a 2cm strip of the red floral trail paper to the bottom of the card.

Make up the pyramage stack - I've done this one with just another layer of scrap card between each piece, stuck with double-sided tape. 

This was because I came to the conclusion that I have so many pyramage cards made up with sticky pads that are just too thick to post. By making up the stacks with card instead, it makes them much firmer - and more importantly, thinner and less bulky to send through the post.

I'll probably do them all with card from now on......

Stick the pyramage to the card with double-sided tape.

Cut a piece of red organza ribbon to measure around 6cm longer than the width of the card blank.

Add 3cm of narrow double-sided tape to each end and add the ribbon to the card so that the top of the ribbon matches with the top of the red paper. Wrap the ends around the back of the card.

Add a greeting with double-sided tape or tacky glue.