This pretty A6 card was made using the Knit one Pearl one (small) pyramage together with the backing paper strip from the motif sheet (or the full-size background paper).

Print the pyramage sheet onto good quality white card - smooth 225gsm card was used here.

Print the background paper sheet onto good quality white paper - hammer paper was used here.

Cut out the pyramage pieces with a craft knife and ruler. Assemble the pyramage using sticky pads - the largest two pieces are fixed together with double-sided tape rather than pads so the stack doesn't get too big.

Stick to the card blank with double-sided tape.

Cut a 3.5cm strip of backing paper, trim it to fit the front of the card blank and affix it using double-sided tape.

Cut a 10.4cm x 5mm strip of plain white card and stick it to the card blank with double-sided tape so that it sits around 4mm from the top of the patterned paper.

Cut a 14cm piece of cerise 3mm satin ribbon and stick narrow double-sided tape along the whole length of it. If you don't have narrow d-s tape, cut a thin strip from wider tape with a craft knife.

Wrap the cerise ribbon around the white strip, folding the end around the back and inside of the card blank.

To finish the card, make a little ribbon bow from another length of cerise ribbon, trim the ends and stick it to the card blank with Aleene's tacky glue. Add a greeting from the pyramage sheet.